|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
22-11-2015, 08:11 PM
|
#1 | ||
|
Regular Member
Join Date: Jun 2015
Posts: 56
|
Hi everyone,
I'm having issues with my Gilmer setup not lining up with each other. The motor had standard pulleys when I bought it, and now it seems that the alternator pulley leans forward more then the other 2 ? I'm not 100% sure if I am using the correct bits for it, as there is a spacer between the head and the alt bracket ? Hopefully you can see from the photo's what I'm talking about. Cheers Last edited by PIGNUTS; 10-05-2018 at 06:10 PM. |
||
|
|
|
22-11-2015, 08:39 PM
|
#2 | ||
|
around the place
Join Date: Jan 2005
Location: Perth
Posts: 1,768
|
can you get a pic with the belt on.
if the belt sits on all three pulleys, the whole width of the belt then it will be fine
__________________
GPS Tracker for your vehicle - PM me for info |
||
|
|
|
|
22-11-2015, 08:50 PM
|
#3 | ||
|
Regular Member
Join Date: Jun 2015
Posts: 56
|
It does seem to sit on well with all 3 pulleys, but I was concerned when it's running, I might have some issues.
Last edited by PIGNUTS; 10-05-2018 at 06:10 PM. |
||
|
|
|
|
22-11-2015, 09:07 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Jan 2005
Location: Brisvagas
Posts: 2,547
|
Are you using a straight edge on each pulley. They may appear lined up but if say the alternator is slightly crooked then you will have issues. Out of alignment and the belt will slide down the pulley.
|
||
|
|
|
302 W belt pulleys not lining up
Linear Mode
